Перейти к содержимому

This design was a joint effort between myself and Red Line Designs, I designed the body, he handled the roll cage which is linked below.

This is an aftermarket back half conversion for the Project IJ.

Designed around the VS410 and VRD platforms, it may not fit other chassis, purchase at your own risk.

Roll cage can be found here: https://youmagine.com/designs/db5a75df-9bf5-404b-a520-b3e9bf4fa416?fbclid=IwY2xjawPwTblleHRuA2FlbQIxMABicmlkETFiamgycVVUdzVOWHp3VERZc3J0YwZhcHBfaWQPNTE0NzcxNTY5MjI4MDYxAAEeiBpjN6gPRfggBgTZsjahbJte4dTRDGJkqMmfUnFrZy3-7UHEEGZRf2KchZ8_aem_iSQ3g01fHf1MewC5bwiwPQ#overview

Files in this set include: New rear subframe, drop bed, 3 bumpers, bed rail, 2 different side panels, tailgate and tailgate trim, Fuel cell.

Fuel cell uses Red anodized vanquish cap.

Based on the Basic kit any full length slider will fit.

Uses file IJ500H for behind the seats.

"This product is a third party compatible with RCMustDIY's Project iJ and is licensed for yellow zones requiring prior consultation. It is compatible with Project iJ and works fine." No original IJ files are included in this set.